Display of crossings

[homer]

Hello
Is this display possible in Kicad?
You can set this in Altium.
I find it makes reading the circuit diagram much easier.

[paulvdh]

Poll: should KiCad support hop-over or not?

Because this seems to be the most important thing ever to decide for the future of KiCad, here’s a poll. See for example How to add crossover or hop over at wire junction? and Junction Dots and hop-overs. Comparison of programs. poll

[BlackCoffee]

This subject has been around for awhile and I grew tired of waiting so, I made a Symbol for it… symbol takes two-minutes to make…

[homer]

Thanks, nice idea but too time-consuming for me.

[BlackCoffee]

@homer

too time-consuming for me

I understand and, given below image (showing the poll was posted in 2021), you may not have to wait much longer, perhaps only a few more years

[JohnRob]

For many years I’ve followed this simple rule: NO connections at crossed wires, ever.

[RaptorUK]

This was the subject of my very first post here

No contact crossing wires

Hi, I’m quite new to KiCad, I’ve created one PCB so far that was a copy of an existing PCB that we didn’t have the layout files for. I’ve got some schematic drawings to do, they aren’t PCBs but cabinet wiring diagrams, I thought I could use Eeschema. My question: is it possible to get Eeschema to show not connected crossing wires with a “bridge” rather than a flat crossed wire ? like this: http://www.ibiblio.org/kuphaldt/electricCircuits/Ref/01048.png

[jmk]

An interesting thought?

If wires A are inadvertently left on B after some Drag function has been used; the result is C.
If Hop-overs/Duck-unders were available and used, would the result of the A to B Drag be D?