Trouble with Labels

[lardom]

@Sprig

I don’t know if you could make the schematic any more difficult to read. And, you are causing yourself the potential for more confusion.

Inputs to the left of the sheet,

and

Outputs to the right of the sheet.

The U2 pin outs for the Symbol do not have to be in numerical order either.

I’ll place the opto-couplers on the output side of the schematic especially because I don’t want to develop bad habits. For the moment I’m modifying an existing pcb and I placed the block of symbols on the input side only because there was more room on that side. I still want to add several more parts and I will use labels to help me get it on a single page.

[pedro]

Move the label to the wire between the connector and the chip. Remove the junction dot.
The signals are connected and the design is cleaner.

[lardom]

@pedro

Move the label to the wire between the connector and the chip. Remove the junction dot.
The signals are connected and the design is cleaner.

Wonderful. I like it. Thanks!