Sync Page settings between schematic and pcb editor?

Software
1

Hi all, I have setup some info in the Page Settings in the Schematic Editor, how do I copy/sync with the PCB Page Settings?

I have found a few pages that say about the fields, like using ${REVISION} (for example) in the PCB settings panel, but it didn’t work. Also tried SCHEMATIC_REVISION from another page but that didn’t work.

I’m probably using the wrong terms searching for it, sorry if this is super obvious!

2

My memory is a bit fuzzy on this but I believe the principle is that variables for each editor are only for that editor, and can’t be “migrated”. However you can define project wide variables which apply to both.

Try this topic: PCB Configuration Variables VS Page Setup Variables - #4 by greg_m

I thought there was a clearer one but I can’t find it.

3

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.