Why are the pins shorting even though the footprint icreated doesn't indicate that?

Why are the pins connecting in pcb ??

They probably aren’t. But because the rast nest lines are all straight if there is a pad directly between two connected pads, the unconnected pad will appear connected because of the rats nest line running across it. There is curved rats nest lines planned, but only available in the not-for-general-use development snapshots. We mere mortals should have access to curved rats nest lines once v6 is released. Until then, zoom in closer and look at the net names on the pins in cases like these.

1 Like

Well the thing is the connections are determined by the schematic so showing us only the layout will not really tell us what we need.

1 Like

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.