Trapezoid Traces

Hey there,
I am new to KiCad. I have done several THD designs with it and now I am working on my first, much smaller SMD design. Normal routing is not a problem, but I have several parts where I want traces coming from a rather small IC to spread out to keep the length of the small diameter zone as short as possible.
The datasheet reconmends the golden layout, I have tried to copy that it with regular traces (bottom) and with filled zones (top):

When using regular traces it looks very unprofessional, but when using filled zones to free form my traces, these zones tend to collide with the GND zone that I add at the end.

Each zone has priority. Set it higher for these zones and Gnd will avoid them.

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.