Switch gamepad?

[hackscribble]

Some ideas here …

Layout challenge: make this contact pad with KiCad?

I’d like to duplicate this pattern as a device: [image] The challenge is that the gold-colored meandering bit is not a conductive trace; it’s the non-conductive gap between the gray-colored conductive areas. For those who care, this is where the conductive pad of a rubber keypad makes contact on the PCB. I my head I picture this as two adjacent filled areas separated by a meandering “keep-out” line. How best to do this in KiCad? Also, there are 30-ish of these, so I’d like to make it a foot…