[SOLVED] ERC error, "pin not connected" for DPDT Switch

In the attached schematic I have a simple circuit using a DPDT Switch to turn on/off some LED’s. I have left Pin 3 on the DPDT Switch unwired for the OFF state of the circuit.

When running the ERC check is gives “Error: Pin not connected” for the unwired Pin 3.

Is there something extra I need to do to avoid the ERC check giving this error whilst leaving the Pin 3 unwired?

Did some further searching and found the answer.

Under the Place menu select “Add No Connect Flag” and place that over the Pin 3.

2 Likes

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.