Simulation editor flaws

Software
1

Hello,
I am using the simulator V8.0.2 (right now with win11 :-p ). It works well enough but I observe two small failures:

  1. When schematic AND simulation window are open I can change the schematic, switch to the simulation, repeat the simulation run (Transient) and the new results will show my changes.
    However the Signal-List will NOT be refreshed. I have to close and reopen the simulation window to see the new components signals.
  2. The Problem with the vanishing input line for self defined Signals is still there !?

Greetings from Chris !

2

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.