Simulating Quiescent Bias Point

[RJBabcock]

I’m not sure if this is the correct forum for this question. Anyway, I’m trying to figure out how to simulate a bias point. I haven’t used spice in about 15 years and I’m still getting my footing.

Any help would be appreciated

[der.ule]

There is a Simulation section, maybe you should move your post there (now it is in Software), there @holger or another expert can help you better. But as a starting point take a look a this links:

NGSpice learning curve

To start with the simulator, in my opinion there is no need initially to fill any of these fields directly. Please have a look at http://ngspice.sourceforge.net/ngspice-eeschema.html for an introduction how to use ngspice from within Eeschema. The KiCad simulator manual is at http://docs.kicad-pcb.org/5.1.2/en/eeschema/eeschema.html#simulator

[holger]

Please do not double post!

Unfortunately KiCad/Eeschema currently does not support operating point simulation.

You may resort to plain ngspice, see the tutorial at http://ngspice.sourceforge.net/ngspice-tutorial.html#rr