Schematic DRC shows no connection but it's there?

[paulvdh]

https://forum.kicad.info/search?q=PWR_FLAG%20category%3A19

ErrType(3): Pin connected to some others pins but no pin to drive it

Additional reading about pin types in general: Electrical type of schematic symbol pins (KiCad 4 and KiCad 5) A good explanation about power symbols can be found in this stackexchange answer by @Seth_h KiCad does check if every component is connected to supply lines (*1) as a missing supply is a common mistake to make. Getting the error “ErrType(3): Pin connected to some others pins but no pin to drive it” means that KiCad thinks that some supply pin is not properly connected. Either because …