when i was trying to fill the zone completely it is not covering up all
area
you mean near the borders?
there is a clearance rule to adjust for that.
What is your perceived problem / expectation?
This ?
Maybe, but reducing copper to edge clearance would be a very bad idea.
At the moment Iām being a bit annoyed because good willing people are wasting time here on someone ho has not even posted a question.
There is also appears a sharp rise in spammers the last few days, so I advise against further guesswork without a decent response from OP first.
2 Likes
This one Mumbai. I am monitoring for a reply by the OP
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.