I’m new with Kicad. I started a few days ago with 4.0.7 and decided to switch to V5 RC1 instead of learning the legacy interface.
My question has to do with the pads in Pcbnew. I see them as red with a magenta border. I’m assuming the magenta border is a keep away zone and not actual copper. If this is the case, where might I be able to increase/change this zone? I looked through all the menu items and could not find it.
BTW I’ve only had V5RC1 installed for a few hours but In my opinion the “feel” and "intuitiveness’ is much better than 4.0.7, I think even than with the OPENGL Canvas.