Net /R20 is graphically connected to bus /<NO NET> but is not a member of that bus

Schematic
1

Capture d’écran du 2023-08-19 13-20-29

What have I to do to say to each wire that they must be connected to the bus ?
Thanks for your help.

I use UBUNTU 22.04 on a Lenovo and KICAD 7.0.7-7.0.7~Ubuntu22.04.1
Patrick

2

You don’t have to do anything to your wires. KiCad already told you they are connected to the bus. But you have to label the bus too. Put the label as shown below on the bus (with TWO dots, not three).

R[0..23]

After that, all your troubles will disappear.
And when you’re all relaxed, read a bit from the manual about how these things work.
It’s easy, just click on Help in the menu in the schematic editor (and then yet another time on Help which appeared just below the first one. then [Ctrl +f] in your favorite browser and search for “bus”.

3

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.