Hello to everyone. I’m new so I hope that this is the right section.
On my schematic I have a kelvin connection with a sense resistor on power output, so I’ve placed a lable for power output and two labels for signal on sense resistor, one of this connect to the power output, doing so I have two different labels for the same wire.
When I check the electrical roules (ERC), I have one error ErrType(5), so my question is how to remove this error mantining the same label?
I think I’ll have some problems even on the layout, but I let this for later.
(PS: I would like to insert a picture, but new users are not enabled. 
)
Thanks,
Fabrizio