FR: Laser GCode Kicad/Inkscape

[pedro]

FlatCAM peut être ?

Noobie Quick Questions

Hi Apurvdate, I have successfully milled a pcb, albeit just the track with no pads. I have written out the proceedure I followed in case your students may find this helpful. In section #3, the dxf imported the traces but no pads. This is not a real problem, I just drilled through the end of each track. I am now going to recreate the boards’ schematic in KiCAD to do the job properly, however, do you know how (in PCBnew) I can add the pads directly onto the B.Cu layer? Regards Gary ========…