Footprint review

I hereby certify that I am not simply asking someone else to design a footprint for me.

This is an auto-generated message that is in place on the “footprints” section of the forum. If I remove it and ask for a footprint to be designed anyway, I understand that I will be subject to forum members telling me to go design my own footprint or referring me to a 3rd party footprint site.

My teammate and I have been working to make the footprint of a certain component, the datasheet of which is listed here->

Here’s the model we’ve created, as a google drive link because apperantly I’m too new to post attachments:

We’re both relatively new to Kicad, and were unable to find a pre-made footprint for this part. Could someone with more experience review this part to make we did it right, or better yet, point us in the direction of a pre-made footprint?

Thanks in advance.

You should be able to upload it here now.

No, the same error is showing up. “new users can’t upload attachments”

You are now a basic user. I wonder if the software is using cached cookies. I don’t remember this being a problem in the past. Going up one level was enough.

Normally just reading posts if a few topics is enough to raise your level. Here it was done by an admin though.

You may also want this …
There is a 3D model here …
And Digikey’s listing shows a STP model, but not a pcb layout module.
I’ll check out your file this evening.

Mouser show an ECAD availability.

This might be useful: Tutorial: How to check footprint correctness? (describes part of the workflow i use for checking contributions to the official library)

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.