Filled copper zone no silkscreen

Layout
1

I’m laying out a SMPS chip and want to create filled zones on the top layer of a four layer board. However, in the 3D view there is no silkscreen over the copper pours. How do I get silkscreen over the copper pours and not over the pads?

Figured it out. Brainfart. I was laying out the zones of to the side of my main board so the silkscreen layer wasn’t there. Duh. I can’t delete the post.

Screen Shot 2020-04-01 at 10.45.02 PM
Screen Shot 2020-04-01 at 10.45.02 PM1138×954 59.8 KB

3

It sounds to me that you are saying silkscreen when you actually mean solder mask.

4

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.