ERC connection error type 2

Schematic
22

Please remember:

  1. Passive components including transistors, triacs, SCR, etc. = Passive pin type, no excuses.
  2. Active components = Read the datasheet pin table, compare with internal schematic, set proper pin type.
  3. If analog pin and not power input or output = Set passive for peace of mind.

Be familiar with PWR_FLAG and “No connect” symbol.

961×554 20.2 KB

The result after symbols clean-up. But I still have some objections about the red areas.

Eeschema doesn’t have (yet) on-line ERC. You have to start it manually. Look for “ladybug” icon on top tool-bar.

1 Like
23

thanks u r appreciated person
ok
i am trying

1 Like
24

according me bridge is correct
because diod are connected in parallel + + and - -.
but if u found any error pls let me know
thanks

25

The bridge may be correct, but you have two grounds, which is incorrect.

26

As drawn D3 is shorted out.
A dc input only uses D2
An ac input blows up D1 or the source

28

A post was merged into an existing topic: How to create footprint for DPAK?