Double click behavior in wire edit

Schematic
1

I just started using kicad 6.0.7 migrated from ver 5 on Windows.

While drawing a wire in the Schematic Editor, double-clicking on an empty space will be finish of wire at the point.
However, if the double-clicked location is a pin of component or junction point on wire, the “Line & Wire & Bus Properties” dialog will shown.
I don’t want this dialog, so I close in frustration.

The dialog was not shown in Ver5.
How to prevent this in Ver6?

2

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.