Diffirent net assigned to a shared pin in another unit of the same component!

[Cagatay]

Hi everyone . I am trying make a copy of STM32F407G-DISC1 card . I found schematic and I started to draw . First I created hierarchical labels because there are six labels in schematic . On first label there were different symbols that were not in Kicad . Therefore I created symbols and ı use global labels .Later I’m getting the following errors . I have lots of problem in my head . Should I use a hierarchical label ? Are the symbols I created and their connections wrong ? You can see all pictures about my problem below . You can reach me from the contact information below . Thank you everyone .

Cagatay Sofu
cagatay_sofu@hotmail.com

[paulvdh]

I’m guessing here that this is your first KiCad project.

I applaud your enthusiasm, but it’s probably better to start with a few small projects.
With a project of this size, you are likely to make some mistake 100 times, and when you’ve noticed you made a mistake, you have to repair it a 100 times.

With a small project it’s much easier to keep an overview of the big picture and if you make mistakes (you will), they are easier to recognize and quicker to fix.

[Rene_Poschl]

You might want to read up what hierarchical design does before you start to think about using hierarchical labels. I hope this would help Hierarchical or flat schematic design, what is best for me? (How to deal with multi page schematics?)

Regarding your error in the title: This indicates that you used a multi unit symbol and assigned the same pin to different nets (also of course means you have a symbol that has the same pin on more than one unit).