Creating different trace shapes

Layout
1

Hi guys
I have just sent a PCB to fab and I needed the awkward trace shape as in image below. After several tries I managed to get it right with just laying several non-angle constrained traces one over each other. Is there a way to do this in KiCad mode elegantly? I tried with copper fills but as there is GND fill around the trace i couldn’t do it without overlapping…
Any ideas? Tried to search web also.

1283×841 10.1 KB

2

Its not a problem if fills overlap, just in that fill change Priority level to 1.

1122×488 22.7 KB

1 Like
3

I tried dozens of options but i just ignored that one :slight_smile:
Thanks Indir, will try that in the morning… Been tracing this board for last 6 hours.

4

Thanks Indir again
I just tried it and can confirm it’s working

831×493 19.2 KB