Connect nets in PCB-mode?

Can I connect two points (nets, I guess) elecrically in PCB editor? Similar to the yellow air wires in Eagle which can (or could) be manipulated in PCB view. I didn’t love everything about Eagle, but this feature I do miss. I suspect it doesn’t make too much sense to most people, but I had to ask :slightly_smiling_face:

In KiCad V5.1.x there is no native way to manipulate the netlist in Pcbnew itself, but there is a plugin scripting module with which you can make connections. It is called “Wire It”

In KiCad-nightly V5.99 (At some furure date to become KiCad V6) It can be done natively in Pcbnew itself.

Nice! Good job. I like.

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.