Autoplace in v5


I don’t know if autoplace is the correct wording so as I have seen in some videos, when a board is created and the netlist is loaded, I can’t seem to find the way to get the parts placed where they are viewable so I can move them around. I’m not looking to have them auto arranged, just spread out a bit like as what has been shown in some vids. I thought F9 would take care of that or by having pcbnew set in legacy but I’m kinda stumped on this one.

Can someone point out what I’m missing please?



In legacy mode (F9), Right-click, Global Spread and Place submenu.

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.