Hello,
It would be nice if there would be an alignment point in the center of a pad when you move a component.
Let me show what i mean:
In this picture i have grabbed Pad 1 of the diode on the left.
Now i want to align the Y-Position of the diode to the center of Pad 2 of Resistor R1.
When you move the Diode Pad over the Resistor Pad, the Pads do not align / snap to the center point.
In this example the grid is aligned to Pad 1 of R1.
Is there already a solution for this?
Otherwise it would be good to create an office feature request.
Best regards,
Dennis