2 different copper fills / nets on front layer

Hi there,

I’m trying to do two separate copper fills for two individual nets on the front copper.
However, when I fill the zones, they get merged into one.
Here’s a screenshot, I hope it’s understandable.
Please don’t mind the sloppy drawing, it’s only a test :slight_smile:
The marked zone ist the one I’m trying to separate from the surrounding zone:

Any help is appreciated!

In the Copper Zone Properties (select Zone and ‘E’), there is a “Zone priority level”. Set that 1 higher than the surrounding zone.

2 Likes

That was it, thank you very much!

1 Like

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.