Problem with solder mask minimum width

solder mask minimum width (in Board setup) seems to have no effect (ver 5.1.4)
solder mask clearance is working as it should.

I tried setting it to 1000mils which should merge pretty well all pads, but it doesn’t.

I couldn’t find any other place to set it??

This setting is used on gerber export.
see How does solder mask layer work?

Thanks, I knew it had to be something simple. I did try to google it, but …

Hopefully this will come up the next time someone tries to google it!

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.